[9000]
| STEP 1 | Remove light in door by removing screw with T10 Torx tool. Slide light assembly out and remove wires. |
| STEP 2 | Remove screw in hole where the light is mounted with T25 Torx tool. (This one is kind of hidden behind insulation material) |
 Thanks to Don Burns for contributing to this FAQ!
| STEP 3 | Remove oval panel under door handle. Pry gently (from the rear to the front) and it will pop out.
After you pull knobs off for mirror adjuster, you will see a small rectangle shape dustcover. Pull back with small scredriver and you will see a clip. Stick small flathead screwdriver in side mirror adjuster prong and push in and push clip forward and pry oval panel out.
|
| STEP 4 | Remove screw holding plastic trim around door handle with T25 Torx. After screw is removed, the trim piece can then be taken off. |
| STEP 5 | Remove round plug in top and bottom of door pull handle. (Pry them to get them started then slide them out) |
| STEP 7 | Remove the covers on the bolt heads on either side of the door pocket. |
| STEP 6 | Remove both screws from top and bottom with T25 Torx. (Don't try to pull the handle off.) |
| STEP 8 | Remove the uncovered bolts with T25 Torx. |
| STEP 9 | Pop the bottom of the door panel off pulling it towards you. There are white nylon inserts that hold it to the door frame.. |
| STEP 10 | Raise the door panel up to loosen it from the top window sill. |
| STEP 11 | The door panel should be free at this point. |
NOTE: A special thanks to Mark Michael here for this contribution to the site. He made this effort to help those of you who need this information. THANKS! TW
|
